How to Build a Catfish Tournament Livewell!

Hey everyone, today I'll show you the custom livewell I built to use in catfish tournaments. All together it costs about $100 to build. I left you a written list of all the parts you need below. If your are confused about any of the parts, take the list to your local hardware store and there is probably someone there that can get you everything you need. If you have any questions feel free to ask. Enjoy!

1 x Tote (40 gallon or more recommended, and don't buy a real flimsy one)
1 x Water pump (Attwood T-500, T-800)
1 x 3/4 in T-fitting (Thread, slip, slip)
2 x 3/4 in Ball Valve (slip, slip)
2 x 3/4 in Barbed fitting (slip, barbed)
1 x 3/4 in to 1/2 threaded to slip reducer fitting
1 x 1/2 in 90 degree elbow fitting (slip, slip)
1 x 1/2 in T-fitting (slip, slip, slip)
1 x 1/2 in End Cap (slip)
2 x 1/2 in Ball Valve (slip, slip)
2 ft of 3/4 in PVC pipe
4-6 ft of 1/2 in PVC pipe
12 ft of 3/4 in Internal Diameter rubber tubing or heater tubing
2 x 3/4 in male end threaded to barbed connector
2 x 3/4 in foot valve
1 x 1/2 in 90 degree elbow (slip, spigot)
4-6 3/4 in to 1 1/4 in hose claps (stainless steel)
1 x marine grade On-Off switch
6 ft of marine grade (tinned copper) 16 or 14 AWG wire
1 x inline fuse receptacle for ATA fuses
1 x set of battery terminal clamps
1 x pack of OUTDOOR cable tie mounting pads
cable ties, PVC cement, and some Teflon thread tape


RSG Outdoors Facebook: www.facebook.com/RSG-Outdoors-104691041273619