@michaelalex5235

This should be a template for all instructional videos that try to address complex tools like Vivado and Vitis.  Xilinx has a lot to learn when it comes to making videos explaining their tools to beginners, IMO.  Thank you very much.

@lokeshprajapati6576

First tutorial so far that I could follow all the way through and everything works. Thanks for the video!

@ayylien5934

Thank you so much for this tutorial, I've been completely clueless on how am I supposed to work with it and had no idea where to start. This tutorial was an incredible starting point and I'm very grateful I stumbled upon it.

@NicolauWerneck

Thanks a lot for this video! I wanted to add a hint for newbies who may be struggling like I did: make sure your MiniZed boot mode is set to 'J' instead of 'F'!

@richardcai4921

This is just the video I need to figure out simply how vivado and vitis cooperate. Thank you very much.

@srdjanbabic8304

Thank you so much for this! I've had a look through at least 5 different tutorials until I saw yours and finally made my board do something!

@86Carrera911

Thanks so much for making this!!! I'm a complete n00b, but you got me started.

@CyberKrish271

Great informative video for beginners.....

@apprentice2101

Thank you very much for the video! It's very helpful.
I wish I could upvote your video more than once

@jakovmatosic4890

THANK U GOAT, U SAVED MY EDUCATION

@paparoach3025

I’m using a Cora Z7 board and when I run the auto router in the block diagram  it throws an error that the clk input is not connected to a valid source. The block diagram didn’t change the way yours did. Any idea what it could be?

@Sandeep-tc1yv

Thankyou very much, this video was extremely helpful.

@emadmojaveri1404

quick and very informative, thanks mate

@dadominicanstyl

Robert great video tutorial, thanks. :)

@sevillajessahmae8109

Hi. can I ask where did the M_AXI_GPO_ACLK go??

@totolovesunsun

It is very helpful. Are you able to put together a video to show us how to utilize the GigiEnthernet on the board the Zynq board and use the Ethernet board to transmit data to another computer?

Thank you for your time!

@kasperbuurvistesen1702

Thanks for this video. Very helpful

@mbuaesenju8514

Very helpful. Thank you.

@chummyelec

I have a question re: minute 20:00. You have got your board plugged in... How is it plugged on? How is the Hello World app downloaded to the board? Over USB/UART? Over Ethernet, where the so called agent on the remote board grabs the files sent and places them in a specific location and runs the app? Over JTAG interface? Cheers

@xEcko6

When attempting to Validate the Design, I keep getting the error ' [BD 41-758] The following clock pins are not connected to a valid clock source: 
/processing_system7_0/M_AXI_GP0_ACLK'.

Any ideas?